This camshaft set consists of two camshafts for your VR6 that includes lube and specs.

Fits all VR6 2.8 2.9L Engines

- 272° duration
- Overlap 113° (Intake/Exhaust)
- Lift 11.2mm (Intake/Exhaust)
- Increase of 10-12 HP

Note: These are used camshafts that have been completely machined, refinished and hardened. A cost effect alternative for quick horsepower gains

Fits Vento/Jetta III, Golf III and Passat (both excluding Syncro) and Corrado.

Set includes front, right rear and left rear mounts. Replace them all at the same time and save yourself money!

Complete set of rings for one piston

Set includes 2 units as pictured

May be used to fasten the water pump

Corresponds to the original VW part number N90221803

Fits all VR6 engines equipped with a 70A alternator

Fits all VR6 engines equipped with a 90A alternator

Fits such alternators as on the VR6 engine.

This lightweight pulley only weighs 143g as opposed to the 370g of the original part. This reduction in weight helps reduce rotating mass which translates into increased performance especially at lower rpm.

Made of 6061 T6 Aluminum

NOTE: Please specify whether or not your car has air conditioning when ordering!

Will not fit 120A Alternators! Please order Item # AZVR004 in this case

- includes an integrated harmonic balancer
- Wights savings of approx. 2,3 kg
- Provides better performance at lower rpm

Used to fasten the crank pulley/harmonic balancer on the crankshaft for the VR6

Corresponds to the original VW part numbers N0100873 and N0100875

Corresponds to the original VW part number N90544202 or N90544203

Polished Stainless Steel. Includes mounting hardware

Please specify your year, model and engine type when ordering

Please specify your year, model and engine type when ordering

For motors with plasic valve cover.